R/E/P Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Multing in a mixerless studio  (Read 1174 times)

Brad Hutchison

  • Newbie
  • *
  • Offline Offline
  • Posts: 29
Multing in a mixerless studio
« on: June 17, 2005, 10:44:04 AM »

Sorry in advance for the basicness of this question, but a forum search didn't come up with an answer.  I would like to mult the output from a preamp into the D/A for a processed leg and an uprocessed leg on the way into a DAW.  Is a simple "Y" cord all I need or do I need  a splitter with some sort of transformer to maintain signal strength, etc.?  Thanks.
Logged

Brian Roth

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 913
Re: Multing in a mixerless studio
« Reply #1 on: June 17, 2005, 11:37:25 PM »

A "Y" should work fine in this instance since your D/A inputs are relatively high impedance in 99.99% of all cases.

Where you would run into problems is driving the inputs of, say, a pair of LA-2As which have 600 Ohm input impedance.

Bri

Logged
Brian Roth Technical Services
Oklahoma City, OK
www.BrianRoth.com

Albert

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 56
Re: Multing in a mixerless studio
« Reply #2 on: June 18, 2005, 10:32:18 AM »

You could also use a patchbay.
Logged
Pages: [1]   Go Up
 

Site Hosted By Ashdown Technologies, Inc.

Page created in 0.021 seconds with 18 queries.