Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[protoolstech]

Hello All,

I have an old ADC patch bay and I'm wondering if there is a way to "bathe" the modules.

Everything is dirty and I was hoping there a safe way to let the modules sit in some type of chemical solution for an over all cleaning before I began soldering.

I'm still going to do a standard cleaning, but the whole thing is so filthy, I'd love to start with a master cleanse.

Thanks for the advice!
V

[RadarDoug2]

If you can find a big enough ultrasonic bath, use that. Use methylated spirits as the liquid in the bath. Make sure your area is well ventilated.

[protoolstech]

I have  a small one, and I'm planning on disasembling the bay for a good clean and repainting the chassis.  I'll give it a shot.

Any idea how long  it  takes.


Thanks,
V

[RadarDoug2]

The bath only runs for 10 minutes per load.

[Pandada]

singapore education

[BlazeEth]

You could try using isopropyl alcohol (90% or higher) for a thorough cleaning. It’s safe for electronics and evaporates quickly without leaving residue. Just make sure to remove any delicate parts beforehand, and avoid soaking for too long. Afterward, let everything dry completely before soldering. You might also want to use compressed air to get rid of any remaining debris.