R/E/P Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Variac for slow ramp up of tube mics?  (Read 283 times)

BluegrassDan

  • Newbie
  • *
  • Offline Offline
  • Posts: 23
  • Real Full Name: Dan Boner
Variac for slow ramp up of tube mics?
« on: July 09, 2020, 09:48:03 am »

Would it be beneficial for the health of a vintage mic’s rare tube and older passive components to slowly bring up the mains AC voltage during each startup? I assume older supply designs have no way of throttling inrush.
Logged
Dan Boner
Associate Professor/Director
Bluegrass, Old-Time, and Country Music Studies
East Tennessee State University

RuudNL

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 63
  • Real Full Name: Ruud van Steenis
Re: Variac for slow ramp up of tube mics?
« Reply #1 on: July 09, 2020, 01:57:40 pm »

Most original (older) power supplies have resistors in series with the filament output.
They function as dropper resistors, reducing the voltage to the right value for the filament.
A filament acts as a PTC. (Positive Temperature Coefficient).
This means that the cold filament has a lower resistance than a heated filament.
A cold filament will cause a higher voltage drop over the series resistors.
As the temperature of the filament rises, the resistance increases and the voltage over the filament will get higher.
So in fact, this is already some kind of 'slow ramping up'.
But it won't hurt to use a variac. No idea if it is worth the trouble...
Logged

klaus

  • Moderator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1853
Re: Variac for slow ramp up of tube mics?
« Reply #2 on: November 21, 2020, 04:47:44 pm »

Great post form RuudNL. I do not use a Variac for adding additional ramp up time. It's overkill, I think.
Logged
Klaus Heyne
German Masterworks®
www.GermanMasterworks.com
Pages: [1]   Go Up