R/E/P Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Amphenol MC4F advice needed  (Read 7884 times)

Vertig07

  • Newbie
  • *
  • Offline Offline
  • Posts: 2
  • Real Full Name: Lance Hoskins
Amphenol MC4F advice needed
« on: November 02, 2017, 01:15:36 PM »

So I'm building a 4-pin amphenol to 3-pin XLR adapter for a Unidyne 545s. I'm no electronics master, but I've done my share of fairly intense DIY projects and for the most part, can build cables in my sleep.

That said, this amphenol connector is a mystery to me... The pins are hollow, and are inset almost 1/4" into the plastic housing, so reaching them with a soldering iron could be a very messy business (and could also melt the plastic). So I'm guessing this is intended to be a solderless connector.

Also, there is a cable clip/tension piece that I haven't quite been able to figure out (see picture).



Does anyone else have experience with this connector? Any advice would be greatly appreciated!

-Lance
Logged
Pages: [1]   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.122 seconds with 18 queries.