Hi All,
I'm a bit stumped here, I have a module on our 9k that is overloading at the mic pre, with no signal. I've seen a variation of this before - what I saw was the meter displaying signal, though there was none, and the overload indicator was lit at the bottom of the meter and on the LED in the channel strip.
1st time I saw it, I swapped out the transistor in the phantom power section - TR100. Then another module went some time later, so I replaced that transistor but no love there. Replaced the caps associated with it, C81 and C252 and happiness ensued.
But this module is doing something else. It seems to be thermal because it only happens when the module is seated. Put it on extender boards and it seems happy. I tried waving a heat gun at it (carefully) but it made me nervous and I don't want to melt it!
Also, one small difference from previous issues is that this one is lighting the overload indicators on meter and LED, but is not showing any signal on the meter. Further, it seems that the phantom power is working okay, the transistor and caps seem to be doing their jobs, but I did replace them as a "go to" measure before being disappointed that my rote approach did not work. But if you have the board in Record mode, turn this channel's mic pre up to about 10 o'clock, the overload lights come on.
At one point, I made a patch into the mic input of the channel while phantom power was on and it made it screw up, but it went away after a minute and I couldn't reproduce it.
I guess I could shotgun the IC's, 5534s and a TL052. I just can't make the issue happen while the circuit is accessible for testing and I'm not sure what my next step is other than to cry about it here, take a lunch break and hope that some inspiration comes my way. When I take it apart, it works and when I put it back together, it doesn't. Ugh.
Thanks for reading this far.
Noah
ETA: I also already swapped/shotgunned the MAT-02 transistor packs, FWIW.
ETA later... W/ module back in place, it sounds like bad op amp noise to me. I guess I'll replace 'em.