R/E/P Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: 1 2 3 [4]  All   Go Down

Author Topic: AKG 414-EB  (Read 16893 times)

compasspnt

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 16266
Re: AKG 414-EB
« Reply #45 on: January 06, 2008, 04:27:00 PM »

bushwick wrote on Sun, 06 January 2008 14:51

How goes the rebuild?



Hey!

I send the dreaded VR off <<to one of the industry's most august experts>> for the complete rebuild this next week.

Once again, if he says OK, I will post about what is being done, and why, and how the microphone changes.

Best regards.
Logged

rob s

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 52
Re: AKG 414-EB
« Reply #46 on: January 06, 2008, 11:28:10 PM »

john musgrve does some amazing upgrades to the V series.
the center section gets a makeover and he has designed his own multi layered motherboards to replace the old ones.
i've used them at conway and they definitely are hugely improved over the stock board.
Logged

seedyunderbelly.com

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2465
Re: AKG 414-EB
« Reply #47 on: January 07, 2008, 04:11:56 AM »

Hi John,


414eb nylon/414eb brass ring

"other then opening them up, how can you tell when surfing ebay for them?"


Sometimes you can tell the difference if there is a good photo of the capsule through the grill.

You can see the white nylon ring,  or the brass surface with the little screws going around.  

I have been able to tell,  sometimes not.  

Careful with this --as some other capsules have the screws also  -you can spot some  pelusos as they are bigger in diameter..(I was temporarily had on this once myself)

thanks j

Pages: 1 2 3 [4]  All   Go Up
 

Site Hosted By Ashdown Technologies, Inc.

Page created in 0.283 seconds with 19 queries.