R/E/P Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: V78 vs V72 Input Transformer  (Read 10186 times)

volki

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 309
V78 vs V72 Input Transformer
« on: February 01, 2007, 09:10:04 AM »

Not sure if this has been asked before - at least I couldn't seem to dig up any info on the following question:

Do V72 and V78 have the same input transformers?

I keep reading this in ads, but when comparing the two schematics, the trannies are labelled differently. So are they actually the same type but just labelled differently, or are we talking about two physically different types?

Thanks for any input,
cheers,
Logged
Volker Meitz

Oliver Archut

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1125
Re: V78 vs V72 Input Transformer
« Reply #1 on: February 01, 2007, 10:35:35 PM »

The x-former in historical V72 and V78 are the same, in schematics they are always listed as the same item, same code, etc. They are hooked up different that is all.

Best regards,
Logged
Oliver Archut
www.tab-funkenwerk.com

We are so advanced, that we can develop technology that can determine how much damage the earth has taken from the development of that technology.

volki

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 309
Re: V78 vs V72 Input Transformer
« Reply #2 on: February 02, 2007, 01:16:53 PM »

Thanks Oliver.

On the schematics I have, it says CTV72/1 and CTV78/1 respectively, which got me confused...  according to your answer, they're both BV191 then.  BV being the more common designation for chokes & transformers in German broadcast equipment, whatever is that CT labelling about? (not "Center Tap", obviously Wink )
Logged
Volker Meitz
Pages: [1]   Go Up
 

Site Hosted By Ashdown Technologies, Inc.

Page created in 0.103 seconds with 22 queries.