R/E/P Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Peluso MX 56 supply questions  (Read 1999 times)

industrial arts

  • R/E/P Forums
  • Newbie
  • *
  • Offline Offline
  • Posts: 9
Peluso MX 56 supply questions
« on: April 20, 2011, 10:46:31 pm »

A friend has a Peluso MX 56 supply and was wondering if it could be used on any of his Neumann mics.  I wasn't sure and think not, the Hi voltage pin (pin 1) on the 7 pin xlr is +104v and the heater voltage (pin 3) is 5.65.  There is no voltage on pin 3, pins 4 & 7 appear to be ground, 5 & 6 are signal.

I'll be the first to admit I'm not well versed in all the various flavors of Neumann mics, so any ideas or help is much appreciated.

Mark Springer
industrial arts
Logged

klaus

  • Moderator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1564
Re: Peluso MX 56 supply questions
« Reply #1 on: April 21, 2011, 02:19:52 pm »

On the low (heater) voltage you could trim down to 4.00 VDC for AC 701 heaters, or 5.00 VDC for the rare Neumann mics with 7586 Nuvistors, but the sticking point will be the high voltage:

The lowest standard B+ voltage a stock Neumann Tube mic will accept is 120VDC.
Logged
Klaus Heyne
German Masterworks®
www.GermanMasterworks.com
Pages: [1]   Go Up