R/E/P Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: 1 [2]  All   Go Down

Author Topic: Mic/Pre impedance "matching"- What Are The Rules?  (Read 61683 times)

klaus

  • Moderator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1950
Re: Mic/Pre impedance "matching"- What Are The Rules?
« Reply #15 on: February 12, 2021, 02:06:16 AM »

Very easy. Bridge the pads either with a fat drop of nicely flowing solder that will flow to both solder points (visible under each resistor) or remove the resistors and solder a small piece of wire across the two solder points
Logged
Klaus Heyne
German MasterworksŪ
www.GermanMasterworks.com

Hermetech Mastering

  • Full Member
  • ***
  • Online Online
  • Posts: 183
  • Real Full Name: Gregg Janman
Re: Mic/Pre impedance "matching"- What Are The Rules?
« Reply #16 on: June 04, 2021, 05:16:34 AM »

Very easy. Bridge the pads either with a fat drop of nicely flowing solder that will flow to both solder points (visible under each resistor) or remove the resistors and solder a small piece of wire across the two solder points

Thanks Klaus. If I posted pics of my KM84s internals, would you be able to tell me what the ohm output strapping was, and if the pads had already been bridged?
Pages: 1 [2]  All   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.063 seconds with 24 queries.