R/E/P > Klaus Heyne's Mic Lab Stickies

Mic/Pre impedance "matching"- What Are The Rules?

<< < (4/4)

klaus:
Very easy. Bridge the pads either with a fat drop of nicely flowing solder that will flow to both solder points (visible under each resistor) or remove the resistors and solder a small piece of wire across the two solder points

Hermetech Mastering:

--- Quote from: klaus on February 12, 2021, 02:06:16 AM ---Very easy. Bridge the pads either with a fat drop of nicely flowing solder that will flow to both solder points (visible under each resistor) or remove the resistors and solder a small piece of wire across the two solder points

--- End quote ---

Thanks Klaus. If I posted pics of my KM84s internals, would you be able to tell me what the ohm output strapping was, and if the pads had already been bridged?

Navigation

[0] Message Index

[*] Previous page