R/E/P Community

Please login or register.

Login with username, password and session length
Advanced search  

Pages: [1]   Go Down

Author Topic: Studer A810 Molex Pin-to-Board Connector  (Read 3279 times)

ryanjblajda

  • Newbie
  • *
  • Offline Offline
  • Posts: 1
  • Real Full Name: Ryan Blajda
Studer A810 Molex Pin-to-Board Connector
« on: April 03, 2014, 07:34:47 AM »

So im basically doing what was done here (http://dibsreaction.com/the-old-studer-speaker-trick/), with a few modifications to the design to make it look a little nicer, but i cant seem to find the pin-to-board connector to connect the ribbon cable to the PCB I am working on soldering up.

I know the pinout thanks to this this thread here (http://repforums.prosoundweb.com/index.php?topic=5238.0) so i figured this might be a good place to start looking to find the right connector. I know its a molex connector thanks to the old thread but i have no idea what type or what the pitch or anything is that i should be looking for on the molex website.

If anyone knows anything or can point me in the right direction, i would appreciate it greatly.


Logged
Pages: [1]   Go Up
 



Site Hosted By Ashdown Technologies, Inc.

Page created in 0.052 seconds with 20 queries.